Rams sheet metal equipment
POWER FLANGER
This unit comes mounted in a heavy duty cabinet. The RAMS-2007 Power Flanger will form a 7/32" right angle flange on either straight or curved pieces. It has an adjustable "auto guide" which can be set to automatically hold the metal for turning the flange on both, a radius or a straight piece.
LOCKFORMER
Button Punch Snap Lock Flanger
Button Punch Snap Lock Flanger
The Lockformer Button Punch Snap Lock Flanger allows you to roll single-direction curves down to a minimum radius of 3-1/2″ inside or a 5″ outside radius, almost automatically. These punched right-angle flanged curves fit perfectly in the receiver formed on the 20 gauge or 24 gauge Lockformer Button Punch Snap Lock Roll Formers.
Manual Flanging Machine
Button Punch Snap Lock Flanger
The Lockformer Easy Edger Manual Flanging Machine turns perfect flanges on elbows or other curved fittings as fast as you can notch them. No gauge to set. Hand clamps to any bench. Available with or without stand. 20 gauge maximum.
Auto-Guide Flanging Machine
Auto-Guide Flanging Machine
The Lockformer HVAC Ductwork Auto-Guide Flanging Machine | Model 16 automatically follows any edge – curved or straight — and uses the convenient table slot to automatically turn up a “starting flange”. A calibrated dial can be set for radii as small as 3-1/4″ (or 2″ when auto-guide is deactivated). Automatically flange 16 to 26 gauge material at speeds of 18 fpm. A non-releasing type head is suitable for open-end fittings, straight and irregular curves. Standard with Lockformer quality construction, this machine has an industrial electric motor, and an arc-welded steel stand protected with Lockformer’s top-quality primer and paint finish.